mini2440通过NFS启动的U-Boot参数设置(二)

2014-11-24 10:46:41 ? 作者: ? 浏览: 1
DMA Driver, (c) 2003-2004,2006 Simtec Electronics
DMA channel 0 at c4808000, irq 33
DMA channel 1 at c4808040, irq 34
DMA channel 2 at c4808080, irq 35
DMA channel 3 at c48080c0, irq 36
S3C244X: Clock Support, DVS off
bio: create slab at 0
SCSI subsystem initialized



……


……


……


TCP cubic registered
NET: Registered protocol family 17
s3c2410-rtc s3c2410-rtc: hctosys: invalid date/time
eth0: link down
IP-Config: Guessing netmask 255.255.255.0
IP-Config: Complete:
device=eth0, addr=192.168.1.230, mask=255.255.255.0, gw=255.255.255.255,
host=192.168.1.230, domain=, nis-domain=(none),
bootserver=255.255.255.255, rootserver=192.168.1.123, rootpath=
Looking up port of RPC 100003/2 on 192.168.1.123
eth0: link up, 100Mbps, full-duplex, lpa 0x45E1
Looking up port of RPC 100005/1 on 192.168.1.123
VFS: Mounted root (nfs filesystem) on device 0:11.
Freeing init memory: 156K
hwclock: settimeofday() failed: Invalid argument
Try to bring eth0 interface up......NFS root ...Done
Please press Enter to activate this console.


[root@FriendlyARM /]#
[root@FriendlyARM /]#
[root@FriendlyARM /]#


-->

评论

帐  号: 密码: (新用户注册)
验 证 码:
表  情:
内  容: