1、

#include

strr1, [r0]

下图的黄色部分表明这出设置的作用，但我不明白，为何要设为0xd，要实现这个目标

@ Xm0CSn2 = NFCON CS0, Xm0CSn3 = NFCON CS1，好像与此处设计无关？

注：

Memory port 0 is shared by using EBI (External Bus Interface).
Memory port 1 is used only by DMC1.

EBI module supports the share of pad interface used by 5 memory controllers (SROMC, two OneNANDCs,
CFCON, and NFCON).

SHARING CHIP SELECT FOR MEMORYPORT 0

The decision of which memory controller owns specific memory bank is decided both by following three
factors.
Booting mode
MP0_CS_CFG regsiter residing in System Controller
XSELNAND input port value

2、

ldrr0, =ELFIN_DMC1_BASE@DMC1 base address 0x7e001000

只读寄存器。

3、

ldr r1, =0x04
str r1, [r0, #INDEX_DMC_MEMC_CMD]

#define INDEX_DMC_MEMC_CMD (0x04)

看到下面的图，应该知道为什么了吧？

配置为：Configure模式

4、

其中有两个寄存器没赋值，如下所示：

下面那个可能采用的是默认值。而上面的是只写寄存器，可能不需要赋值。