In this Document

APPLIES TO:

Oracle GoldenGate ? Version 4.0.0 and later
Information in this document applies to any platform.
***Checked for relevance on 14-12-2012***

FIX

Problem
How do I restore the checkpoint table so Replicat can use it again?

Typical error
Depending on the problem, these errors can appear as "No data found" or "Table does not exist".
Such as:

GGS ERROR 516 Extract read, No data found selecting position from checkpoint table HR.REPCHECK for group REPORA, key 1181389907 (0×4669453).

Or…

2005-10-25 13:22:16 GGS ERROR 516 Extract read, Checkpoint table HR.REPCHECK does not exist. Please create the table or recreate the REPORA group using the correct table.

Cause
The table is probably corrupt, was deleted, or is missing a row(s).

Solution
1. Issue the INFO REPLICAT command in GGSCI to verify that the checkpoint FILE on disk is intact. If it errors, the file is missing or corrupt, and you should contact GoldenGate technical support. If the file is intact, continue with these steps.

2. If the table was deleted, recreate it with same schema and name as before … or, if it is corrupt or missing a row, truncate it.

3. From the GoldenGate home location, run the convchk utility with the following command, specifying the checkpoint table as shown:
convchk .

4. Restart Replicat.

5. SELECT from the checkpoint table to verify that checkpoints are being added again.

Running convchk causes the checkpoint FILE to become the master source for the group's checkpoints. On restart, Replicat will populate the new or truncated checkpoint table with the data from the checkpoint file, in effect resynchronizing them.